XQ-IME360/390/585 Epoxy Injection Anchor Adhesive

XQ-360e

 

 

 

 

 

 

 

 

 

XQ-IME360/390/585

Production Information

Adopted with modified epoxy resin and nano composite materials, XQ-IME series Injection Anchoring Adhesive are two-component,styrene free system for use as a high strength, non-shrink anchor grouting material. Its advantage on steel bar planting has been proved by many testimonies. Compares with other adhesive, it is a new high performance, Eco-friendly anchoring adhesive which has strong bonding strength and high-efficiency as well as irritation free and low odor.

Range of Application

  • All concrete building without embedded steel bar
  • Reinforcement and reconstruction of buildings with concrete
  • Reinforcement and reconstruction of Railway, Road, Bridge, Water resources, Tunnel, etc.
  • Reinforcement for equipment, pipeline installation, supports of curtain wall.

Features

  • High bonding strength, good flexible performance similar as embedded.
  • Ageing resistance, good heat tolerance and does not creep at ambient temperature;
  • Low sensitivity in moist condition with long-term load stability;
  • Acid-resistant, good shock resistance, stress-free fixed;
  • Good thixotropy, particularly applicable to the sides or top surface anchoring;
  • Two-cylinder direct-mix package, with a dedicated glue gun without manual mixing
  • Product performance

1 Basic parameters

1) Appearence:                             Part A (main): white cream      Part B (hardener): red cream / grey cream

2) Mixed Viscosity:                     18-22Pa.s

3) Hardened density:                  1.50±0.10g/cm3

4) Mixing ratio (Volume ratio): 360ml (5:1) / 390ml (3:1)  / 400ml (1:1) / 500ml (3:1)

5) Shelf time:                                18 months

2 Main Performance

Testing project  Condition  Index
Gel Performance (According to China National Standard GB50728-2011)
Splitting Tensile Strength (MPa) Under (23±2)℃、(50±5)%RH, tested by loading speed of 2mm/min ≥8.5
Bending Strength (MPa) ≥50(no fragment damage)
Compressive Strength (MPa) ≥60
Bonding Capacity (According to China National Standard GB50728-2011)
Steel-Steel Tensile Shear Strength (MPa) (23±2)℃、(50±5)%RH ≥10
Bonding strength of Ribbed steel bar (or screw) with concrete under constrain drawing condition (23±2)℃ (50±5)%RH C30,Ф25,L=150mm ≥11
C60,Ф25,L=150mm ≥17
Steel-Steel T-peeling strength (mm) (23±2)℃、(50±5)%RH ≤25
Non-volatile content (105±2)℃、(180±5)min ≥99%
Ageing resistance to heat and humidity  90d
Reduction rate of tensile strength Under normal room temperature ≤12%
(According to China National Standard JGJ145-2013)
Tensile Strength  (after high temperature welding) Dia12 Grade II steel, C30 concrete Hole dia.16mm, Depth: 150mm 55.1N, 57.0N, 54.8N